SHINESTAR STEEL GROUP CO., LTD

盛仕达钢铁股份有限公司

Causes of pits on the surface of seamless steel pipes and treatment methods

Continuous pits on the surface of seamless steel pipe

cause:

1. Heavy wear on the rolls and grooves

2. The roll is not cooled well, and the surface is sticky steel

3.The surface of the conveying roller table is not smooth

4.The high temperature heating time of the abandoned tube in the heating is too long, resulting in overheating and overheating.

5.The sizing high-pressure water is not normal to remove phosphorus, and the iron oxide scale is clearly and uncleanly pressed into the surface of seamless steel pipe

Treatment method: replace the frame or repair the roller surface.

Seamless steel tubes are made of steel ingots or solid tube blanks by perforation to form capillary tubes, and then made by hot rolling, cold rolling or cold drawing. Compared with solid steel such as round steel, steel pipe is lighter in weight when the bending and torsional strength is the same.It is an economic cross-section steel, widely used in the manufacture of structural parts and mechanical parts, such as petroleum drill rods, automobile transmission shafts, and bicycles. And steel scaffolding used in building construction.


Post time: Jan-14-2020

We use cookies to offer a better browsing experience, analyze site traffic, and personalize content. By using this site, you agree to our use of cookies.

Accept