SHINESTAR STEEL GROUP CO., LTD

盛仕达 钢铁 股份有限公司

Фитинги и фланец

  • Крышка

    Крышка

    Pipe caps act as protective device and are designed to protect pipe ends of various shapes. The main purpose of using pipe caps is to waterproof the connections. They are also used to close the the ends of hydraulic or pneumatic pipes and tubes. They are used in the plumbing apparatus of domestic, commercial and industrial water supply lines, machinery and processing equipment etc. They are also fitted on water pump lines with the sole purpose of removing air blocks. Pipe caps are highly dema...
  • угольник

    угольник

          Seamless Elbow Manufacturing Process (Heat Bending & Cold Bending) One of the most common methods for manufacturing elbows is using hot mandrel bending from straight steel pipes. After heating the steel pipe at a elevated temperature, the pipe is pushed, expanded, bend by the inner tools of mandrel step by step. Applying hot mandrel bending can manufacture a wide size range seamless elbow. The characteristics of mandrel bending are strongly depend on the integral shap...
  • сгибать

    сгибать

    1. Bend tubing: Tube bending is the umbrella term for metal forming processes used to permanently form pipes or tubing. One must differentiate between form-bound and free form-bending procedures, as well as between heat supported and cold forming procedures. 2. Processes: Tube bending as a process starts with loading a tube into a tube or pipe bender and clamping it into place between two dies, the clamping block and the forming die. The tube is also loosely held by two other dies, the wiper ...
  • тройник

    тройник

    Pipe Tee, Tee Fittings A tee is also called triplet,three way and “T” pieces and it can be used to either combine or split a fluid flow. Most common are tees with the same inlet and outlet sizes, but ‘reducing’ tees are available as well. it means the one or two ends are differ in dimension.due to thisdimension differ,the makes the tee fittings with the capacity to control the volume when requried. Steel pipe tee has three branches that can change fluid direction. It h...
  • Пересекать

    Пересекать

    Pipe cross comes into equal cross and reducing cross,and the raw materials of which include a wide range, like carbon steel, alloy steel, stainless steel, low temperature steel, and high performance steel, etc. Our pipe crosses feature high strength, good toughness and resistance to corrosion, and they are widely used in many industries, such as petroleum, power generation, natural gas, chemical, shipbuilding, paper making etc. Pipe Cross Types Equal Cross The equal pipe cross is one type of ...
  • редуктор

    редуктор

    A steel pipe reducer is a component used in the pipelines to reduce its size from large to small bore in accordance to the inner diameter. The length of the reduction here is equal to an average of the smaller and larger pipe diameters. Here, the reducer can be used as  a nozzle. The reducer helps in meeting the existing piping of varied sizes or hydraulic flow of the piping systems.
  • Фланцы

    Фланцы

    1. Slip-on pipe flanges  Slip-on pipe flanges actually slip over the pipe.  These pipe flanges are typically machined with an inside diameter of the pipe flange slightly larger than the outside diameter of the pipe.  This allows the flange to slide over the pipe but to still have a somewhat snug fit.  Slip-on pipe flanges are secured to the pipe with a fillet weld at the top and the bottom of the slip-on pipe flanges.   These pipe flanges are also further categorized as a ring or a hub 2. We...